Use and Care Manual

Rev. B
Page 11
Scene Chase
To initiate a scene chase, record scenes 1-4 as shown in the above Recording Scenes section, then
follow the example below:
Procedure: Notes:
1. Press [SC/CH] until LED is On
2. Raise Master Fader to 100% (full)
3. Raise Faders 1-4 to 100% (full)
4. Press [CHASE 1]
5. Adjust [SPEED] control to set rate Scene 1-4 LED’s flash
6. Press [PROG] to reverse direction
Chase 1 will activate Scenes 1-4, Chase 2 will activate scenes 5-8.
Audio Chase
A channel or scene chase can also be triggered by an audio input (Max. input -10 db 100mV).
Adjustment of the audio signal is via the Audio Sensitivity control located on the underside of the
console.