Use and Care Manual

Chapter 1 Introduction
2 egaP N3004 / N3008 User Guide
About the Console
The N3000 series of lighting control consoles are designed to be both simple and intuitive to operate,
just plug it in and go!
Features
Features available depend on the model you purchased:
Model
N3004 N3008
Channel Faders: 04 08
Scenes: 04 08
Bump Buttons: 04 08
Chases: 02 02
Chaser Functions
Chaser functions on all models include the ability to chase either factory programmed individual
channel patterns or user programmed scenes. See
Chase
section for more information.
Specifications
• Power supply: DC 12V/ 1A
• Control signal: DMX512 / 1990
• Control channels: 4 or 8, depending on model
• Connectors: XLR 3-pin(x1), XLR 5-pin(x1)
• Audio input: Max. input -10 db 100mV
• Weight: N3004 1.1Kg (2.4Lbs), N3008 1.2Kg (2.4Lbs)
• N3004 Dimensions: 200L x 170W x 51H mm (7.87L x 6.69W x 2.00H inches)
• N3008 Dimensions: 237L x 170W x 51H mm (9.33L x 6.69W x 2.00H inches)
In order to eliminate possible erratic behavior while controlling DMX devices, always use a DMX
terminator, especially when long runs of control cable are used. A terminator is a 90-120 ohm 1/4 watt
resistor that is connected between pins 2 (DATA -) and 3 (DATA+) of a male XLR connect
or.
Warnings
Cautions
• To avoid fire, shock or death, do not remove the ground prong from the power cord.
• To avoid fire, shock or death, do not expose the unit to rain, moisture or other contaminants.
• To avoid shock, never operate this unit with its cover removed.
• Do not operate this unit if it becomes damaged in any way.
• Do not operate this unit if power cord is frayed or broken.
• If the unit has been stored in a cold environment (below 40ºF), do not turn the power on until it
warms up or else damage may occur.
• Make sure that the main’s power outlet matches the required voltage for your unit.