Product Overview

ManualsBrandsLeviton ManualsElectricalLeviton ODS10-ID Decora 120/277-Volt Wall Switch Occupancy Sensor, White

PRODUCT DATA

ODS10-ID

ODS10

Decora

Wall Switch PIR

Occupancy Sensor

BASIC OPERATION

The Leviton Decora

Wall Switch Passive

Infrared (PIR) Occupancy Sensor (ODS10-ID)

uses Passive Infrared (PIR) detection technology

to monitor a room for occupancy through a

segmented Fresnel lens. This specialized lens

divides the field-of-view into sensor zones.

When a person passes into or out of a sensor

zone, the sensor detects motion and switches

the lights ON. The lights will remain ON as long

as there is an occupant moving through the

sensor zones.

APPLICATIONS

The ODS10-ID is used to provide automatic

lighting control for energy savings and

convenience in a variety of commercial

applications, including:

• Small offices • Lounges

• Conference rooms • Classrooms

The ODS10-ID can be used for automatic

switching of LED, incandescent lamps and

fluorescent and low-voltage lighting with

electronic or magnetic ballasts. The unit also

features a manual override switch that can

be used to keep lights OFF while an area is

occupied, which may be desired in conference

rooms and other areas during slide or film

presentations. The unit installs in place of a

single-pole wall switch and fits in a standard wall

box. The unit requires a ground connection.

Leviton Manufacturing Co., Inc. Global Headquarters

201 North Service Road, Melville, NY 11747-3138 tech line 800-824-3005 fax 800-832-9538

Summary of content (4 pages)

PAGE 1
PRODUCT DATA Decora® Wall Switch PIR Occupancy Sensor ODS10-ID APPLICATIONS The ODS10-ID is used to provide automatic lighting control for energy savings and convenience in a variety of commercial applications, including: • Small offices • Lounges • Conference rooms • Classrooms The ODS10-ID can be used for automatic switching of LED, incandescent lamps and fluorescent and low-voltage lighting with electronic or magnetic ballasts.
PAGE 2
ODS10 PRODUCT DATA FEATURES • Fits in standard wallbox and replaces single-pole wall switch. Gangable with other units. • Low-profile design eliminates obtrusive “scanning-device” look. Elegant Decora wallplates complement any interior for sleek aesthetics; uses Decora wallplates and coordinates with Leviton’s popular line of Decora wiring devices.
PAGE 3
DIMENSIONAL DIAGRAMS 1.75” (44.4mm) Mounting Yoke Vandal Resistant PIR Lens 0.48” (12.6mm) 1.30” (33.0mm) 1.35” (34.4mm) Blinders Control Panel, Cover Removed BLINDERS 10 20 4 7 2.60” (66.2mm) 2.61” (66.3mm) 4.06” (103.
PAGE 4
PRODUCT DATA INSTALLATION The ODS10-ID may replace a single-pole wall switch mounted in a standard wallbox. The unit must be properly grounded in order to operate. The unit’s integral blinders may be used to restrict the fieldof-view to prevent unwanted detection of hallway traffic. It should be positioned at least 6 feet away from HVAC registers. Note that whenever the unit is powered up, it will take approximately one minute to begin normal operation.