Installation Guide

5
5. NOTE: Ensure that Gasket is seated on Sensor Mounting Plate before
wiring.
Connect wires per appropriate WIRING DIAGRAM, use 14AWG conductors
with 600V/105°C insulation: Twist strands of each lead tightly and, with
circuit conductors, push rmly into the appropriate wire connector. Screw
connector on clockwise making sure that no bare wire shows below the
connector. Secure each wire connector with electrical tape.
6. Carefully position the wires into the xture, then mount the Sensor Mounting
Plate onto the weather-resistant xture tting with the screws provided.
7. After positioning and adjusting the sensor (refer to Figure 3), restore power
at circuit breaker or fuse. INSTALLATION IS COMPLETE.
ADJUSTMENT AND OPERATION
The Walk Test is used to check and adjust the coverage pattern of the
Sensors. The Sensor will enter the WALK TEST mode 30 seconds after power
has been applied to the unit. This will initiate approximately a 5 minute WALK
TEST period. During these 5 minutes, the sensor will operate in daylight and
will keep its lighting load on for 5 seconds after motion ceases. Test as follows
(refer to Figure 4):
1. Aim the Sensor across the area it will be monitoring.
2. Turn ON power to the unit at the fuse or circuit breaker.
3. After power has been ON for at least 30 seconds, the sensor is
automatically set for the WALK TEST mode.
Figure 3 - Mounting Position
Correct
Incorrect
Incorrect
4. Atornille la perilla roscada en el brazo del Sensor en el hueco del centro de
la placa de pared.
5. NOTA: Asegure que la empaquetadura esté metida en la placa de Montaje
del Sensor antes de cablear.
Conecte los conductores de acuerdo al DIAGRAMA DE CABLEADO
apropiado, use conductores con aislante 600V/105°C: Tuerce los hilos de
cada conexión bien apretados y empújelos rmemente en el conector de
alambres. Enrosque cada conector hacia la derecha, asegurando que no se
vea ningún conductor desnudo debajo del conector. Asegure cada conector
con cinta aislante.
6. Coloque los conductores dentro del sujetador, luego monte la placa del
Sensor en el sujetador de montaje resistente a la intemperie, con los
tornillos provistos.
7. Después de colocar y ajustar el Sensor (ver Figura 4). Restablezca la
corriente con el fusible o interruptor de circuito. LA INSTALACION ESTA
COMPLETA.
Figura 3 - Posición de Montaje
Correcto
Incorrecto
Incorrecto
24