Instructions / Assembly

EZ-MAX Plus Installation Guide Page 25
LOW VOLTAGE
Low Voltage Control Wiring
Once the power wiring has been completed, you can begin the control wiring. Control
wiring can be divided into two categories: analog and digital. Remote relay panels
only support analog control inputs.
Control Overview
The Leviton EZ-MAX Plus relay products are simple yet powerful, and can be operated
by multiple control sources. Control input to a relay cabinet can be any combination of
the following:
• Low Voltage momentary or maintained through a discrete input.
• Momentary 2-Pole On/Off through a discrete input.
• Photocell 0-10VDC or Switched through a discrete input.
• Occupancy sensor through a discrete input.
• Dry Contacts through a discrete input.
• Digital control inputs (See “Wiring the Phoenix Connector” on page 40).
Please see “Product Specifications and Capabilities Chart” on page 3 for more
information on the quantity and types of inputs available for each cabinet. All inputs
(except network inputs) support every type as shown above.
The specific wiring requirements for each input type are discussed on the following
pages.
Each product (and in some cases each model of a
product) has a slightly different layout at the terminal
blocks. The specific function of each terminal is labeled on
the circuit board adjacent to the terminal blocks. When
wiring the inputs, verify that you are connecting the
correct wire to the correct terminal based on function,
even if it deviates from what is shown in this
documentation. Contact our technical services
department with any further questions.