Instructions / Assembly

EZ-MAX Plus Installation Guide Page 35
LOW VOLTAGE
Photocells
The relay cabinet is capable of supporting the following types of photocells:
• Switched Photocell (On/Off, trigger point set at photocell).
• 0-10V Photocell.
The configuration and behavior of your photocell is set via software (see the EZ-MAX
Plus Programmer’s Guide for details). This section only covers installation.
Photocell Wiring
Step 1: Connect leads per wiring diagram as illustrated in one of the following
figures:
Figure 19: 0-10VDC Photocell Wiring
IN +V COM
Terminal order/function may differ from
that shown. Confi rm on cabinet circuit
board or I.D. label.
IN +V COM
Common
(DC Ground)
Power (+24VDC)
Control Signal
(+0-10VDC)
PhotoCell
Terminal order/function may differ from
that shown. Confi rm on cabinet circuit
board or I.D. label.