Instructions / Assembly

EZ-MAX Plus Installation Guide
Page 1
Read this Before You Begin!
Safety Precautions!
 Read and follow all safety instructions.
 Apply the “Emergency Circuits” label (provided) to the front of the
door.
 When using electrical equipment, basic safety precautions should
always be followed.
 Do not use outdoors.
 Do not mount near gas or electric heaters.
 Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by authorized personnel.
 The use of accessory equipment not recommended by manufacturer
may cause an unsafe condition.
 Do not use this equipment for other than intended use.
 All servicing shall be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS!
Leviton Service and Support:
www.leviton.com 1-800-959-6004
Warnings!
 Conduit Entry Locations: The cabinets have been designed with
specific locations supporting conduit entry for line and low voltage
circuits. There are specific areas of the cabinet that are restricted
from some or all types of conduit access. See the Installation
sections of this manual for specific details.
 Line and load circuit wiring: The line wiring should come from an
over-current device and the load circuit wiring should go to the
specific load to be controlled. On some models that have
integrated branch circuit protection, the line side of the relay has
been pre-wired to a circuit breaker. Only the load side of the circuits
needs to be connected with these products.
 To be installed and/or used in accordance with appropriate electrical
codes and regulations.
 To be installed by a qualified Electrician.
 DO NOT CONNECT line voltage wires to low voltage terminals.
 Mount in a location where audible noise is acceptable.
 When using with fluorescent ballasts, both lighting fixture and
ballast must be grounded.