Instructions / Assembly

Luma-Net III Wiring Specifications
Page 40
Wiring the Phoenix Connector
Step 1: Connect leads per the wiring diagram below.
Step 2: Twist strands of each lead tightly (making sure that there are no stray
strands) and push firmly into appropriate plug connector location.
Step 3: Tighten the screws on the plug connector—making sure that no bare
conductor is showing.
Step 4: Tie the Drain/Shield wires together and insulate using a small piece of
heat shrink tubing.
REM+
REM -
COM
TERM
LOCK
+V
1
2
3 4 5
6
Up
to
1 #12AWG
2#12AWG
2#12AWG
Up to
1 #12AWG
Drain/Shield - Insulated and tied together
(Ground at one point only-
probably an end)
Red (+V )
Black (Common)
5
6
1
2
3
4
Phoenix/Luma-Net Connector