User Manual

FEDERAL COMMUNICATION COMMISSION

INTERFERENCE STATEMENT FCC STATEMENT

FCC RADIATION EXPOSURE STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the speciﬁc operating instructions for satisfying RF exposure

compliance. To maintain compliance with FCC RF exposure compliance requirements, please

follow operation instructions as documented in this manual. This transmitter must not be co-

located or operating in conjunction with any other antenna or transmitter. This equipment should

be installed and operated with a minimum distance of 20 cm between the radiator and your

body. The availability of some speciﬁc channels and/or operational frequency bands are country

dependent and are ﬁrmware programmed at the factory to match the intended destination. The

ﬁrmware setting is not accessible by the end user.