How to Guide

ManualsBrandsLevolor ManualsBlinds1936058

Page 1 of 11 Trim&Go! Wood Blind Shortening Instructions

Levolor Aluminum and Vinyl Blind Shortening Instructions

The following are instructions to shorten Levolor Trim & Go aluminum and vinyl

blinds. To see a detailed video of this operation, visit our website at:

http://www.levolor.com/products/blinds/trimandgo/metal-blinds/ or

http://www.levolor.com/products/blinds/trimandgo/vinyl-blinds/

Necessary Tools:

Step 1: Install and lower the blind fully

Summary of content (11 pages)

PAGE 1
Levolor Aluminum and Vinyl Blind Shortening Instructions The following are instructions to shorten Levolor Trim & Go aluminum and vinyl blinds. To see a detailed video of this operation, visit our website at: http://www.levolor.com/products/blinds/trimandgo/metal-blinds/ or http://www.levolor.
PAGE 2
Step 2: Select the slat that is even with the window sill or slightly below it, this will become the new bottom slat of the blind Step 3: Pry all the plugs from the underside of the bottom rail Page 2 of 11 Trim&Go! Wood Blind Shortening Instructions
PAGE 3
Step 4: Pull the excess lift cords through the bottom of the rail Cut the lift cord to remove the plugs; save the plugs for later Page 3 of 11 Trim&Go! Wood Blind Shortening Instructions
PAGE 4
Step 4: Slide the bottom rail out of the cords Cut all cords approx 6 in.
PAGE 5
Step 5: Pull the lift cords free of the slats below Page 5 of 11 Trim&Go! Wood Blind Shortening Instructions
PAGE 6
Remove all the excess slats from below the new bottom slat Step 6: Insert the bottom rail between the ladder cords just below the new bottom slat Page 6 of 11 Trim&Go! Wood Blind Shortening Instructions
PAGE 7
Insert the lift cords back through the hole from the top of the rail Remove the pieces of lift cord from the plugs Page 7 of 11 Trim&Go! Wood Blind Shortening Instructions
PAGE 8
Insert the lift cords through the top of the plugs Slide the plugs to the bottom rail and tie a knot below them (for the moment, do not insert the plugs into the holes) Page 8 of 11 Trim&Go! Wood Blind Shortening Instructions
PAGE 9
Step 7: Trim the excess ladder cords approximately 2 in.
PAGE 10
Trim away excess lift cord below the knot Step 8: Twist together the ladder cords and slide them into the hole in the bottom rail Page 10 of 11 Trim&Go! Wood Blind Shortening Instructions
PAGE 11
Insert the plugs, securing the ladder cords; make sure to secure the ladder cords in the plug notches Finally, install the bottom rail end caps onto the bottom rail Now enjoy your PERFECTLY sized blinds from Levolor! Page 11 of 11 Trim&Go! Wood Blind Shortening Instructions