Quick Start Guide

// Getting started
1 Connect your microphone to your mixing console, audio interface
or microphone preamplifi er using a 3-pin XLR cable.
2 Set the input gain on your mixing console, preamp, etc. accordingly.
3 To ensure best sound quality, do not cover any part of the grille.
4 Rock!
// Overview
// Dynamic kick drum/bass microphone
// Cardioid polar pattern for effective isolation of the main sound source
// Tailored frequency response for drum and percussion applications
// Switchable EFR (Enhanced Frequency Response) to emphasize
frequencies relevant for kick drum sounds
// Recessed slide switch
// Integrated acoustic pop and windshield - washable
// Solid full-metal die-cast body
// Gold plated & corrosion-resistant 3-pin XLR output connector
Top applications // Kick drum, toms, percussion and bass instruments
// User interface
1 Modes slide switch // Select between the two following modes by adjusting the slide switch:
= ‘Flat Frequency Response’ – FFR // Suited for recording bass-heavy instruments.
+ ‘Enhanced Frequency Response’ – EFR // Emphasizes frequency ranges relevant for the kick drum sound.
Boosts frequencies from 70 to 150 Hz for a full bass sound and frequencies between 3 and 5 kHz for fast attack.
// Please Note
// The capsule is a sensitive, high precision component. Make sure you do not drop it from high heights and avoid strong mechanical
stress and force.
// To ensure high sensitivity and best sound reproduction of the microphone, avoid exposing it to moisture, dust or extreme
temperatures.
// Do not apply excessive force on the switches or the connected cable.
// When disconnecting the microphone cable, grasp the connector and do not pull the cable.
// Do not attempt to modify or fi x the microphone, as it would void your product warranty.
// The casing of the microphone can be cleaned easily using a wet cloth,
never use alcohol or another solvent for cleaning.
// The windshield can be washed with soap water, if necessary.
1
LEWITT
®
Burggasse 79
1070 Vienna
Austria
www.lewitt-audio.com
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
READ THE
FULL MANUAL!
LEARN EVERYTHING ABOUT YOUR DTP 340 REX
www.lewitt-audio.com/resources/manuals/DTP-340-REX.pdf
// DTP 340 REX
QUICKSTART GUIDE
MASSIVE LOW END AND SNAPPY PUNCH MULTIPURPOSE PERCUSSION MICROPHONE FOR ALL BASS-HEAVY APPLICATIONS