Installation Guide

Removing ‘Stuck-on Product Label’ From Sheet
• First method: Try saturating the label with soapy lukewarm water to loosen the adhesive. The label
should remove easily after about 15 minutes of soaking.
• Second method: Wet a soft cloth with rubbing alcohol (isopropyl alcohol). Place the cloth on the
label face. Leave it sit until the rubbing alcohol has soaked through the label (approx. 15 minutes).
Starting at one corner, carefully peel o󰀨 label.
Note: For stubborn labels, spray Goo Gone on the face of the label and let it sit for roughly 15 minutes to
completely penetrate the label. Begin at one corner of the label and slowly peel o. If you use Goo Gone,
MAKE SURE to clean the area where the label was with soapy lukewarm water and rinse thoroughly to
remove any oily residue.
Additional Information
If additional technical, loading, or system information is needed, please contact Polymershapes. If you
have a specific question about requirements in your region, contact your local code office or
building inspector.
Drawings and technical reports are provided for reference only. Drawings are not project-specific and
are for product representation only. Actual products may vary. These drawings are the property of
Polymershapes and are to be used solely as a representation of Polymershapes products. These
designs may not be recreated or produced without the expressed, written consent of Polymershapes.
All information, recommendations, or advice given by Polymershapesemployees or partners, written
or oral, is given in good faith and is thought to be accurate and current. It is the responsibility of
each product user to ensure the product is used in compliance with current environmental and legal
requirements specific to each product application. Polymershapes and its partners will not be held
liable for incorrect or improper use of its products.
POLYMERSHAPES HEREBY DISCLAIMS ANY WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
IMPLIED WARRANTY OF MERCHANTABILITY AND/OR IMPLIED WARRANTY OF FITNESS FOR A
PARTICULAR PURPOSE. POLYMERSHAPES SHALL NOT BE LIABLE FOR ANY INCIDENTAL,
CONSEQUENTIAL, OR PUNITIVE DAMAGES.
[e-mail] | [phone]
21
MULTIWALL POLYCARBONATE
Technical & Install Guide