Lexicon LE45 mobile computer p Q i k Start Quick St t Guide G id www.lexicontech.
Features front and side views 1. Power Button 2. LCD display 3. Right Scan Trigger Button 4. Left Scan Trigger Button 5. USB-C connector 6. Keypad 7. Battery 8. Notification LEDs 8 5 2 4 3 6 1 www.lexicontech.
Features rear,, top p and bottom views 1. Data Capture Window 2. Bottom Pogo Pin 3. Speaker 4. Handstrap clip 5. Battery pack 6. Handstrap Bar 1 6 3 5 2 4 www.lexicontech.
Getting g started cradling g and charging g g Charging the device by power adapter 1. 2. 3. Insert the small end of power adapter into the USB-C jack g the large g end of p power adapter p into a p power outlet Plug Charging status LED on device • • Green LED = charged over 90% Red LED = charging Important notes 8 hours is recommended for the 1st time charging. Recharge of 6000mAh will take 4-5 hours for 80% battery capacity. ww.lexicontech.
Getting g started cradling g and charging g g Cradling the device 1. Sliding the device into the device with slight angle Slightly push the device back The device is sitting on the cradle in a secure manner 2. 3. Charging the device 1. Connect the power supply to the cradle, make sure the cradle orange LED is blinking Put the device on the cradle Charging status LED on device 2. 3 3.
Getting g started Installing handstrap 1. 2. 3. 4 4. 5. Remove screws from handstrap holder. Separate the velcro of the handstrap. Feed the loose end of the extended handstrap through the handstrap clip Wrap the handstrap around the clip and fasten together to close the strap Install the screws back to handstrap holder. ww.lexicontech.
Getting g started Enablingg & disablingg WiFi Enabling WiFi 1. 1 2. 3. 4 4. Tap Apps icon, icon then select Settings Go to Network connections, turn on WiFi Tap the WiFi text on the setting screen A list of WiFi networks appears appears, pick the desired AP and setup as the wireless AP properties as usual Disabling WiFi 1. 2. Tap Apps icon, then select Settings Go to Network connections, turn off WiFi ww.lexicontech.
Getting g started Enablingg & disablingg BT Enabling Bluetooth 1. 1 2. 3. 4 4. Tap Apps icon, icon then select Settings Go to Network connections, turn on Bluetooth Tap the Blyetooth text on the setting screen A list of bluetooth devices appears appears, pick the desired device to pair up Disabling Bluetooth 1. 1 2. Tap Apps T A icon, i then th select l tS Settings tti Go to Network connections, turn off Bluetooth ww.lexicontech.
Getting g started reboot and factoryy data reset Performing reboot 1. 1 2. Long press power button A menu appears , keep to hold the power key until the device reboot Performing factory data reset 1. 2 2. 3. Tap Apps icon, then select Settings In Personal section section, select Back up and reset Select Factory data reset, click Reset phone www.lexicontech.
Getting g started Refreshingg ROM Refreshing RT55 ROM 1 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Copy RT55 ROM zip file to the root directory of the microSD card Open the battery cover, remove the battery Insert the microSD card Install the battery to the battery compartment Press and hold the power button and the F2 button for few seconds Continue to press and hold the F2 button and power button until the update screen appears Press F2 and select [Recovery Mode], then press F1 to select.
Getting g started Refreshingg ROM 11. 12. Select Yes – delete all us, press enter Finallyy select “reboot system y now” to reboot the device 11 11 ww.lexicontech.
Getting g started Enablingg scanner Enabling scanner 1 1. R Remove the h scanner fil film on the h scanner window 2. Tap Apps icon, then select ScanDemo 3 3. P Press th the scanner button b tt on the th device d i tto scan the barcode 4. Barcode data will be shown on the screen Scan button ww.lexicontech.
Getting g started Batteryy warningg Battery safety guidelines 1. 2. 3. 4. 5. 6. 7. 8. 9 9. Use manufacturer's original g battery y and charger g only. y Any y incompatible p battery y or charger may result in a fire, explosion, or other hazard. Do not disassemble or open, crush, bend or deform, puncture, or shred the battery. Do not short-circuit a batteryy by y allowing g conductive materials to contact the battery y terminals. Do not immerse or expose the battery to water or other liquids.
Regulation g and maintenance FCC and Canadian Compliance Tested to Comply with FCC Standards. LE45 mobile computers meet or exceed all applicable standards and have been manufactured to the highest level of quality. Waste Electrical and Electronic Equipment (WEEE) Information This product has required the extraction and use of natural resources for its production. production It may contain hazardous substances that could impact health and the environment, if not properly disposed.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
