Owner's Manual

Basic Operation Lexicon
2-22
Unlike most other menus, status menus cannot be opened by
selecting menu options. The remote control command sequence
outlined below must be executed.
To open and navigate the STATUS menu for the current input
source:
1. Press and release the remote control SHIFT button.
2. Press and release the remote control STAT button.
The first page of the STATUS menu for the current input source
appears in the on-screen and front-panel displays.
3. If the > indicator appears near the top right corner of the menu,
press and release the STAT button again to open the second
page. Press and release the STAT button again to open the
third page (if one exists).
If the STATUS menu does not include a second or third page,
pressing and releasing the STAT button again closes the menu.
Note:
When viewing a STATUS menu on the front panel display, press the
remote control MAIN button, then press the  or  arrow button to
scroll up or down through the list of available parameters.
4. Press the STAT button to close the STATUS menu. In some
cases, you must press STAT twice in succession to close the
STATUS menu.
Note:
STATUS menu parameters provide information about the current
input source and listening mode. These parameters cannot be
adjusted.
D STATUS
INPUT
MODE
CHANNELS
BIT RATE
RL
EX ENCODED
>S
CSL
SR
LFE
dB
0
-6
-15
-30
-45
D STATUS
SAMPLE RATE
2.0 ENCODING
DIALOG OFFSET
MIX ROOM
CENTER MIX LVL
SURR MIX LVL
HDMI STATUS > S
HDMI CONNECTOR
VID FMT
VERT RATE
AUD IN
AUDIO FMT
CHANNELS
SAMPLE RATE
HDCP STATUS
S