Owner's Manual

SETUP
Lexicon
3-44
5 ST. & (1) 5.1 ANLG (continued)
When the analog audio input connectors are configured as
five stereo and one 5.1-channel connectors:
•Two-channel sources that were assigned to the stereo
connectors are reassigned to the corresponding 5.1-channel
connectors. The 5.1-channel connectors should only be used
with 5.1-channel analog sources such as DVD-As and SACDs.
2 ST. & (2) 5.1 ANLG
Configures the analog audio input connectors as two stereo and
two 5.1-channel connectors.
When the analog audio input connectors are configured as
two stereo and two 5.1-channel connectors:
• The connectors labeled 1 and 2 are configured as stereo
connectors.
• The connectors labeled 3, 4 and 5 are configured as a
5.1-channel connector and the connectors labeled 6, 7 and 8
are configured as a 5.1-channel connector. These connectors
are sent to the audio output connectors as indicated in the
table in the next column.
•Two-channel sources that were assigned to the stereo
connectors are reassigned to the corresponding 5.1-channel
connectors. The 5.1-channel connectors should only be used
with 5.1-channel analog sources such as DVD-As and SACDs.
2 ST. & (2) 5.1 ANLG

REAR PANEL CONFIG

SETUP
5 ST. & (1) 5.1 ANLG

REAR PANEL CONFIG

SETUP
The 5.1-channel analog audio input connector is sent to the
analog audio output connectors as shown in the table below.
Input Connector Output Connector
(L) Front L
(R) Front R
(C) Center
(SUB) Subwoofer
(LS) Side L and Rear L
(RS) Side R and Rear R