User's Manual
Table Of Contents
- Introduction
- Setup
- Troubleshooting
- An indicator light is not on
- I can not find the network settings of my computer’s wireless adapter
- My MAC address is not listed on the Select your N5 Wireless Adapter screen
- My network is not listed on the Connect to the network (automatic) screen
- I do not know the hexadecimal format of my WEP key
- Setup was not successful (My printer was not found on the network)
- The Lexmark printer software installation screen does not appear
- An error message appears
- There is not a Network button on the Results: No Printer Attached screen
- My network printer does not appear in the list of available printers
- There is not an Install Selected Printer button on the Network Configuration screen
- My network printer does not print
- How Do I...?
- Glossary
Getting Started
5
Step 6: Connect your adapter
power supply
If necessary, replace the US power plug adapter with the
correct power plug adapter for your geography.
Step 7: Make sure all indicator
lights are on
If, after 30 seconds, one or more of the indicator lights are
not on or blinking, see page 22.
Note: The Network link light blinks to indicate any
network activity in the area.
1
Power supply
3
2
US
power
plug
adapter
Power light
Network link light
USB light