User's Manual
Table Of Contents
- Introduction
- Setup
- Troubleshooting
- An indicator light is not on
- I can not find the network settings of my computer’s wireless adapter
- My MAC address is not listed on the Select your N5 Wireless Adapter screen
- My network is not listed on the Connect to the network (automatic) screen
- I do not know the hexadecimal format of my WEP key
- Setup was not successful (My printer was not found on the network)
- The Lexmark printer software installation screen does not appear
- An error message appears
- There is not a Network button on the Results: No Printer Attached screen
- My network printer does not appear in the list of available printers
- There is not an Install Selected Printer button on the Network Configuration screen
- My network printer does not print
- How Do I...?
- Glossary
Getting Started
8
Lexmark confidential until announced
Follow the instructions on your screen to change
the values of your computer’s wireless adapter
network settings.
Do not exit the Lexmark Printer Adapter software.
You need to have both utilities active at this time.
Use the space below to write down the current
values of the network settings. You may need to
refer to them later.
SSID/Network name __________________
Mode ______________________________
Channel ____________________________
WEP/Authentication __________________
Key________________________________
Return to the Lexmark Printer Adapter software
after all settings have been changed and the
configuration utility for your computer’s wireless
adapter has been closed.
If there is only one printer adapter on your
network, continue with step 12 on page 9.
If there are two or more printer adapters on your
network, select your adapter from the list of
available network devices.
7
8
9
10
Your adapter is the
device whose MAC
address matches the
MAC address on the
bottom cover of your
adapter.
MAC address