User's Manual
Table Of Contents
- Introduction
- Setup
- Troubleshooting
- An indicator light is not on
- I can not find the network settings of my computer’s wireless adapter
- My MAC address is not listed on the Select your N5 Wireless Adapter screen
- My network is not listed on the Connect to the network (automatic) screen
- I do not know the hexadecimal format of my WEP key
- Setup was not successful (My printer was not found on the network)
- The Lexmark printer software installation screen does not appear
- An error message appears
- There is not a Network button on the Results: No Printer Attached screen
- My network printer does not appear in the list of available printers
- There is not an Install Selected Printer button on the Network Configuration screen
- My network printer does not print
- How Do I...?
- Glossary
Getting Started
10
Lexmark confidential until announced
Follow the instructions on your screen to restore
the original network settings.
Do not exit the Lexmark Printer Adapter software.
You need to have both utilities active at this time.
Return to the Lexmark Printer Adapter software
after all settings have been restored and the
configuration utility for your computer’s wireless
adapter has been closed.
Click Continue.
You are finished setting up your adapter on the
network.
– If you connected your adapter to an inkjet
printer, click Finished, and then continue with
Configure your Lexmark inkjet printer on
page 11.
– If you connected your adapter to a laser printer,
a network port for your laser printer is created.
Click Finished, and then continue with
Configure your Lexmark laser printer on
page 16.
15
Press continue when the computer has returned to the network where
the N5 adapter has been placed.
Return to your network settings
Using your computer’s wireless network utility, change the network settings to the
values that you saved when you started or to new network values that you have
selected where the N5 adapter is connected.
Reset your computer’s wireless adapter.
2. After you reset your computer’s wireless adapter, press continue to
complete the setup of your wireless printer adapter.
1.
7
Back Exit
Your wireless printer adapter has been set to:
SSID = value from screen 4 or 5
mode = value from screen 4 or 5
channel = value from screen 4 or 5
encryption = value from screen 6
16
17
18
Continue setup with printer driver
Finish the printer setup using the printer CD or installed printer software as indicated in the
printer adapter getting started manual.
A network printer port is defined
Wireless setup is complete. A network printer port has been created that contains the
name of the printer and the last 6 digits of the MAC address similar to the following:
Lexmark_E320_0035D0
If your printer driver is already installed, go to section XXX of the adapter getting started
manual for instructions on connecting your printer to the network port.
If the printer has not been installed, install the printer to the network port following the
instructions that came with your printer.