User's Manual
Table Of Contents
- Introduction
- Setup
- Troubleshooting
- An indicator light is not on
- I can not find the network settings of my computer’s wireless adapter
- My MAC address is not listed on the Select your N5 Wireless Adapter screen
- My network is not listed on the Connect to the network (automatic) screen
- I do not know the hexadecimal format of my WEP key
- Setup was not successful (My printer was not found on the network)
- The Lexmark printer software installation screen does not appear
- An error message appears
- There is not a Network button on the Results: No Printer Attached screen
- My network printer does not appear in the list of available printers
- There is not an Install Selected Printer button on the Network Configuration screen
- My network printer does not print
- How Do I...?
- Glossary
Getting Started
25
Lexmark confidential until announced
2 From the Printer Installation screen, click Configure
Network Printer.
3 Continue with step 4 on page 12.
My network printer does not appear in the
list of available printers
• Unplug the adapter power supply, and then plug it in
again.
• Make sure all cables to the printer, adapter, electrical
outlet, and network connection are secure (pages 4
through 5).
• Click Refresh.
• If your network printer is on a remote subnet, click
Add Printer, and then follow the instructions on your
screen.
• Restart the computer.
There is not an Install Selected Printer
button on the Network Configuration
screen
1 From the Network Configuration screen, click Close.
2 From the Printer Installation screen, select your
printer port from the pull-down menu, and then click
Next.
3 Follow the instructions on your screen to complete
software installation.