User's Manual
Table Of Contents
- Introduction
- Setup
- Troubleshooting
- An indicator light is not on
- I can not find the network settings of my computer’s wireless adapter
- My MAC address is not listed on the Select your N5 Wireless Adapter screen
- My network is not listed on the Connect to the network (automatic) screen
- I do not know the hexadecimal format of my WEP key
- Setup was not successful (My printer was not found on the network)
- The Lexmark printer software installation screen does not appear
- An error message appears
- There is not a Network button on the Results: No Printer Attached screen
- My network printer does not appear in the list of available printers
- There is not an Install Selected Printer button on the Network Configuration screen
- My network printer does not print
- How Do I...?
- Glossary
Getting Started
31
Lexmark confidential until announced
Reset the adapter
If you encounter problems during setup or later decide to
move your adapter to a different network, you may need to
reset the adapter.
To reset the adapter:
1 Verify all indicator lights are on (page 5).
2 Press the Reset button using a pen or pencil.
3 Verify the USB light goes out momentarily.
Contact Lexmark
Visit our Web site at www.lexmark.com to:
• Receive technical support.
• Register your adapter.
Other ways to contact our Customer Support Center:
• From the Lexmark Solution Center, click Contact
Information Customer Support.
• Insert the printer software CD that came with your
printer into your CD-ROM drive, and then click
Contact Lexmark Technical Support.
• Insert the Lexmark N5 Adapter Setup Utility software
CD into your CD-ROM drive, and then click Contact
Lexmark Technical Support.