User's Manual
Table Of Contents
- Introduction
- Setup
- Troubleshooting
- An indicator light is not on
- I can not find the network settings of my computer’s wireless adapter
- My MAC address is not listed on the Select your N5 Wireless Adapter screen
- My network is not listed on the Connect to the network (automatic) screen
- I do not know the hexadecimal format of my WEP key
- Setup was not successful (My printer was not found on the network)
- The Lexmark printer software installation screen does not appear
- An error message appears
- There is not a Network button on the Results: No Printer Attached screen
- My network printer does not appear in the list of available printers
- There is not an Install Selected Printer button on the Network Configuration screen
- My network printer does not print
- How Do I...?
- Glossary
Getting Started
3
Step 3: Prepare your printer
Unpack and set up your printer. For help, refer
to the instructions that came with your printer.
To help configure your printer on the network:
– Do not connect your printer to your
computer; however, if you have already done
so, disconnect the USB or parallel cable.
– Do not install the printer software; however, if
you have already done so, you do not need
to uninstall it.
Place the printer next to your adapter.
Note: If necessary, disconnect the printer
power supply, and then reconnect it at its
new location.
Make sure the printer power light is on.
Note: Your printer may look different from the
one shown.
1
2
3
4