Operation Manual

5 Push the memory card into the connector until it clicks into place.
Installing a flash memory or firmware card
The system board has two connections for an optional flash memory or firmware card. Only one of each may
be installed, but the connectors are interchangeable.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer
o,
and unplug the power
cord from the wall outlet before continuing. If you have any other devices attached to the printer, then
turn them o as well, and unplug any cables going into the printer.
Warning—Potential Damage: System board electronic components are easily damaged by static electricity.
Touch something metal on the printer before touching any system board electronic components or
connectors.
1 Access the system board.
For more information, see
“Accessing the system board” on page 22.
Notes:
• This task requires a flathead screwdriver.
• Do not unplug the fan cable upon opening the metal panel.
2 Unpack the card.
Note: Avoid touching the connection points along the edge of the card.
Additional printer setup 26