Operation Manual

3 Holding the card by its sides, align the plastic pins on the card with the holes on the system board.
2
1
1 Plastic pins
2 Metal pins
4 Push the card
firmly
into place.
Notes:
• The entire length of the connector on the card must touch and be
flush
against the system board.
• Be careful not to damage the connectors.
Installing an Internal Solutions Port
The system board supports one optional Lexmark Internal Solutions Port (ISP).
Note: This task requires a flathead screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer o, and unplug the power
cord from the wall outlet before continuing. If you have any other devices attached to the printer, then
turn them o as well, and unplug any cables going into the printer.
Additional printer setup 27