Operation Manual

Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touch

something metal on the printer before touching any system board electronic components or connectors.

1 Access the system board.

For more information, see

“Accessing the system board” on page 9.

Note: This task requires a flathead screwdriver.

2 Unpack the ISP kit.

1 ISP solution

2 Screws for the ISP solution

3 Screw for the plastic bracket

4 Plastic bracket

3 Locate the appropriate holes on the system board where the posts of the plastic tee will be aligned.

Note: If an optional printer hard disk is currently installed, then remove it first. For more information, see

“Removing a printer hard disk” on page 23.

Additional printer setup 16