Operation Manual

Use To
Alarms
Alarm Control
Cartridge Alarm
Set an alarm when the printer requires user intervention.
For each alarm type, select from the following options:
• Off
• Single
• Continuous
Notes:
• Single is the factory default setting for Alarm Control and
Cartridge Alarm. This sounds three quick beeps.
• Continuous repeats three beeps every 10 seconds.
Timeouts
Standby Mode
Disabled
1–240
Set the amount of time in minutes before the printer enters a lower
power state.
Note: 15 is the factory default setting.
Timeouts
Sleep Mode
Disabled
1–120
Set the amount of time in minutes the printer waits after a job is
printed before it goes into a reduced power state.
Notes:
• 20 is the factory default setting.
• Lower settings conserve more energy, but may require
longer warm‑up times.
• Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in the
room.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Timeouts
Hibernate Timeout
Disabled
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Set the amount of time the printer waits before it enters Hibernate
mode.
Note: 3 days is the factory default setting.
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Set the printer to Hibernate mode even if there is an active Ethernet
connection.
Note: Do Not Hibernate is the factory default setting.
Timeouts
Screen Timeout
15–300
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
Understanding printer menus 148