Printer User Manual
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
Section 8: Barcodes
158
Since the b0 bit of the c parameter has a value of 01 (check digit by printer),
there must be 7 data characters (x07) specified in the Data Transfer Command.
Invalid EAN-8 command:
The letter ’C’ is not a valid data character for EAN-8; the numbers ’0’-’9’ are the
only valid characters.
>x
1B5B66 - barcode setup command prefix
0600 - setup data length (low byte first) -
x0006, 6
B3 - barcode type = EAN-8
00 - module width = default
00 - space width adjustment = default
4003 - height (low byte first) - x0340 = 832 =
0.385 inches
01 - control byte: check digit from host, print
human readable character
1B5B70 - barcode data transfer command prefix
0700 - data transfer length (low byte first) -
x0007, 7
>058C454 ...