Manualshelf

User's Manual

ManualsBrandsLexmark ManualsAir ConditionersLexmark Lexmark Air Conditioner 9EZ
12345678910
6
GB
Fan mode
1. Press the MODE BUTTON [6] until the symbol appears next to FAN.
2. Use the FAN SPEED BUTTON [7] to set the fan speed.
3. Use the SWING BUTTON [3] and the AIR FLOW BUTTON [4] to adjust the air flow direction.
Sleep button
Press the
SLEEP BUTTON [5], the symbol appears on the right hand side of the display
next to
SLEEP. Press again to release the sleep mode.
In this mode the air flow sound is reduced. Use the sleep mode when you are going
to bed.
In
COOL mode operation, the room temperature will be raised gradually 2 °C higher
than the setting when SLEEP mode was activated.
In HEAT mode operation, the room temperature will be lowered gradually 5 °C lower
than the setting when SLEEP mode was activated.
When the SLEEP MODE is selected, the display on the unit will dim to be seen well in a
dark room without causing distraction to sleep.
Turbo button
During COOL or HEAT mode operation, the air flow rate (the amount of air circulating
through the room) can be increased. Press the TURBO BUTTON [9], the symbol
appears on the right hand side of the display next to TURBO. Press this button again
to cancel the turbo operation and return to the other air flow rates.
Timer button (timed switching off )
1.
Press the TIMER BUTTON [8] to enter the “timed” mode when the unit is switched on.
2. Press this button to set after how many hours the air conditioner should switch
off. The symbol in the display cycles through 1 2 ... 24 cancel (no
indication) 1... with each press of the button.
Once the set time has elapsed (the symbol shows the remaining number of
hours) the air conditioner will switch itself off. To cancel this function before the set
time has elapsed, press the TIMER BUTTON [8] again.
Timer button (timed switching on)
The air conditioner is switched off (stand-by).
1. Press the TIMER BUTTON [8] to enter the “timed” mode.
2. Press this button to set after how many hours the air conditioner should switch
on. The symbol in the display cycles through 1 2 ... 24 cancel (no
indication) 1... with each press of the button.
3. Set the desired operation, temperature, fan speed, etc.
Once the set time has elapsed (the symbol shows the remaining number of
hours) the air conditioner will switch itself on. To cancel this function before the set
time has elapsed, press the
TIMER BUTTON [8] again.
Hold button