Service Manual

2-68 Service Manual
4062
260.02 Envelope feeder
assembly error
Mechanical feed error or timing
error.
1. Remove the envelope
feeder.
2. Remove all media present
in media path.
3. Check media for proper
installation.
4. Check for obstructions in
media path.
5. Ensure the envelope feeder
assembly is properly
installed.
6. Check all connections on
the envelope feeder
assembly.
7. Replace the envelope
feeder assembly if problem
remains.
260.05 Sensor (envelope
feeder pass through)
lingering jam
Source = Envelope
feeder
The media reached the sensor
(envelope feeder pass through)
but did not clear it in the
specified time.
1. Remove the envelope
feeder.
2. Remove all media present
in media path.
3. Check for obstructions in
media path.
4. Ensure the envelope feeder
assembly is properly
installed.
5. Check all connections on
the envelope feeder
assembly.
6. Replace the envelope
feeder assembly if problem
remains.
260.06 Sensor (envelope
feeder pass through)
late jam
Source = Envelope
feeder
The media is late reaching the
sensor (envelope feeder pass
through) within the specified
time.
1. Remove the envelope
feeder.
2. Remove all media present
in media path.
3. Ensure envelope feeder is
not overfilled.
4. Check, clean or replace the
envelope feeder pick roll for
wear and excess
contamination.
5. Check all connections on
the envelope feeder.
6. Check all connections on
the system card assembly.
7. Replace the envelope
feeder assembly if problem
remains.
8. Replace system card
assembly if problem
remains. Go to “System
card assembly removal
(T650, T652, T654, T656)”
on page 4-76.
Error
code or
message
Error contents Description/Action Possible repair actions