Service Manual

Diagnostic information 2-81
4062
28x.64
x = bin
number
Bin clamp motor
control timer error
during tray holder
initial.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.65
x = bin
number
Bin clamp home
position jam
Applies to:
StapleSmart finisher
The bin clamp home position is
not detected by the sensor (bin
clamp HP)
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.66
x = bin
number
Bin clamp home
position jam
Applies to:
StapleSmart finisher
The sensor (bin clamp HP)
does not detect that the bin
clamp has moved from home
position.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.67
x = bin
number
Invalid bin clamp
manager state.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.68
x = bin
number
Staple ready home
position jam
Applies to:
StapleSmart finisher
The sensor (self priming) within
the stapler assembly does not
detect a ready staple prior to a
staple job.
Staples empty
1. Check all the connections on
the controller card and the
stapler assembly.
2. Remove the staple cartridge
and remove all jammed
staples. If the cartridge is
jammed and can not be
removed, go to step 3.
3. Remove the stapler
assembly.
Go to “SFP stapler assembly
stapler unit assembly
removal” on page 4-182.
4. Manually rotate the drive
gears and reset the stapler.
Remove all jammed staples
then reinstall the stapler
assembly.
5. If problem remains, replace
the stapler assembly.
Go to “SFP stapler assembly
stapler unit assembly
removal” on page 4-182.
Error
code or
message
Error contents Description/Action Possible repair actions