Service Manual

Diagnostic information 2-143
4062
3
Check the duplex guide assembly, front for damage.
Is the above component free from damage?
Go to step 4. Replace the
duplex guide
assembly, front.
Go to “Duplex
guide assembly,
front removal
(T652, T654)” on
page 4-21.
4
Check the sensor (duplex input) for proper operation.
1. Enter the diagnostic mode
2. Select Duplex tests
3. Select sensor test
4. Observe the line item “input”
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
Go to step 6. Go to step 5.
5
Check the above sensor for proper connection.
Is the above sensor connected properly?
Replace the
sensor (duplex
input).
Go to “Sensor
(duplex input)
removal (T652,
T654)” on
page 4-68.
Replace the
connection.
6
Check the aligner assembly for obstructions.
Is the above component free from obstructions?
Go to step 7. Remove
obstructions.
7
Check the external duplex media path for obstructions.
Is the above component free from obstructions?
Go to step x Remove
obstructions.
8
Check the external duplex unit assembly for proper
installation.
Is the above component properly installed?
Go to step 9. Remove then
properly re-install
the external
duplex unit
assembly.
9
Check the sensor (duplex input) for proper operation.
1. Enter the diagnostic mode
2. Select Duplex tests
3. Select sensor test
3. Observe the line item “input”
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
Go to step 10. Replace the
external duplex
assembly.
10
Perform a print test using the duplex.
Does the problem remain?
Contact next
highest level of
tech support.
Problem solved.
Step Check Yes No