Service Manual

Repair Information 4-125

4062-XXX

3. Remove the HCIT drawer slide.

High capacity input tray (HCIT) tray lift drive motor assembly removal

Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.

1. Remove the HCIT cover, right. Go to “High capacity input tray (HCIT) cover, right removal” on

page 4-120.

2. Remove the HCIT cover, left. Go to “High capacity input tray (HCIT) cover, left removal” on page 4-122.

3. Disconnect the HCIT tray lift drive motor cable connector from the HCIT controller card assembly.

Note: Remove the cable from the restraint, and observe the routing for reinstallation.

4. Remove the eight screws (A) securing the HCIT tray lift drive motor assembly.