Service Manual

4-192 Service Manual

4062-XXX

Stapler/stacker controller card assembly removal

1. Remove the left cover. Go to “SFP stapler assembly left cover removal” on page 4-173.

2. Disconnect all harnesses to the controller card.

3. Remove the three screws (A) securing the stapler/stacker controller card assembly.

4. Remove the stapler/stacker controller card assembly.

Sensor (HCIT tray raised HP) with cable assembly removal

Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.

1. Remove the HCIT cover, left. Go to “High capacity input tray (HCIT) cover, left removal” on page 4-122.