Service Manual

Diagnostic information 2-23
4062
201.78 Image data did not
start in time
Type 2 fuser
Fuser page count has
exceeded life
Printhead write failure 1. Check all connections on the
printhead assembly
2. Check all connections on the
system card assembly.
3. Replace the printhead
assembly if problem remains.
4. Replace the system card
assembly if problem remains.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
201.79 Sensor (narrow
media) late jam
Type 2 fuser
Fuser page count has
exceeded life
The media is late reaching the
sensor (narrow media) within
the specified time.
Go to sensor (narrow media)
late jam service check.
See “Sensor (narrow media)
late jam service check.” on
page 2-139.
201.80 Operator panel door
assembly interlock
switch open failure
Type 2 fuser
Fuser page count has
exceeded life
The printer detected that the
switch (operator panel door
interlock) did not cycle prior to
printer restart.
1. Remove all media present
in media path.
2. Ensure that the operator
panel door assembly is fully
open then fully closed.
3. Check operator panel door
assembly for damage.
4. Check interlock switch (in
left operator panel hinge)
for damage.
5. Check all connections on
the system card assembly.
201.81 Sensor (narrow
media) late jam
Type 2 fuser
Fuser page count has
exceeded life.
The media is late reaching the
sensor (narrow media) within
the specified time.
Go to sensor (narrow media)
late jam service check.
See “Sensor (narrow media)
late jam service check.” on
page 2-139.
201.82 Sensor (fuser output)
late jam
Type 2 fuser
Fuser page count has
exceeded life
The media is late reaching the
sensor (fuser output) within the
specified time.
Go to sensor (fuser output) late
jam service check.
See “Sensor (fuser output)
late jam service check.” on
page 2-135.
Error
code or
message
Error contents Description/Action Possible repair actions