Service Manual

Diagnostic information 2-33
4062
230.02 Sensor (duplex input)
late jam
Source = Internal
duplex
Media is late reaching the
sensor (duplex input) within the
specified time.
Go to sensor (duplex input) late
jam service check.
See “Sensor (duplex input)
late jam service check.” on
page 2-141.
230.03 Sensor (duplex input)
bounce
Source = Internal
duplex
The sensor (duplex input)
rebounded once the trailing
edge of the media passed.
Go to sensor (duplex input)
service check. See “Sensor
(duplex input) service
check” on page 2-127.
230.04 Sensor (input) late
jam from duplex
Source = Internal
duplex
Media is late reaching the
sensor (input) within the
specified time during the
second side printing using the
internal duplex.
Go to sensor (input) late jam
service check.
See “Sensor (input) late jam
service check.” on
page 2-129.
230.05 sensor (duplex input)
lingering jam
Source = Internal
duplex
Media reached the sensor
(duplex input) but did not clear
it in the specified time.
Go to sensor (duplex input)
lingering jam service check.
See “Sensor (pass through)
late jam service check” on
page 2-145.
230.06 Sensor (input) late
jam from duplex
Source = Internal
duplex
Media is late reaching the
sensor (input) within the
specified time during the
second side printing using the
internal duplex.
Go to sensor (input) late jam
service check.
See “Sensor (input) late jam
service check.” on
page 2-129.
230.07 Sensor (input) late
jam from duplex
Source = Internal
duplex
Media is late reaching the
sensor (input) within the
specified time during the
second side printing using the
internal duplex.
Go to sensor (input) late jam
service check.
See “Sensor (input) late jam
service check.” on
page 2-129.
230.08 Internal duplex drive
motor load error
Source = Internal
duplex
The internal duplex drive motor
assembly has failed or caused
high mechanical load during
warm up sequence.
1. Remove all media present
in media path.
2. Check all connections on
the duplex media entrance
drive motor assembly.
3. Check all connections on
the system card assembly.
4. Replace the duplex drive
motor assembly if problem
remains. Go to “Duplex
drive motor assembly
removal (T652, T654)” on
page 4-19.
Error
code or
message
Error contents Description/Action Possible repair actions