Service Manual

2-46 Service Manual
4062
242.18 Pick retry timeout
Source = Tray 2
The engine timed out waiting
for the tray 2 to report ready
before the first pick attempt.
Turn the machine off/on.
242.19 Pick retry timeout
Source = Tray 2
The engine timed out waiting
for the tray 2 to report ready
before a pick retry attempt.
Turn the machine off/on.
242.52 Tray 2 pick motor
overrun failure
Source = Tray 2
The Pick motor encoder
continues to detect pulses after
the motor was turned off.
1. Check all connections on
the pick arm assembly.
2. Check all connections on
the system card assembly.
3. Replace the pick arm
assembly if problem
remains. Go to “Operator
panel door assembly
removal (models X651,
X652, X654, and X656)”
on page 4-49.
242.33 Tray 2 not ready
Source = Tray 2
Tray was not properly pushed
into the machine.
1. Check the size sensing
fingers on the media tray
for damage
2. Replace the media tray
assembly if problem
remains.
3. Check the switch (media
size) for proper connection.
4. Replace the switch (media
size) if problem remains.
Go to “Switch (media
size) assembly removal
(T650, T652, T654)” on
page 4-74.
242.34 Empty tray pick
attempted
Source = Tray 2
The pick arm attempted to pick
with no media in the tray.
1. Check the media out
actuator for damage.
2. Replace the media out
actuator if problem
remains. Go to “Tray roller
catch assembly removal
(T650, T652, T654)” on
page 4-81.
242.35 Pick page received
while POR not yet
done.
Source = Tray 2
Media remains on the sensor
(input) during the warm up
sequence.
Go to sensor (pass through)
static jam service check.
See “Sensor (pass through)
static jam service check” on
page 2-147.
242.36 Sensor (pass through)
static jam
Source = Tray 2
Media remains on the sensor
(input) during the warm up
sequence.
Go to sensor (pass through)
static jam service check.
See “Sensor (pass through)
static jam service check” on
page 2-147.
242.37 Sensor (pass through)
late jam
Source = Tray 2
The media is late reaching the
sensor (pass through) within
the specified time.
Go to sensor (pass through)
late jam service check.
See “Sensor (pass through)
late jam service check” on
page 2-145.
Error
code or
message
Error contents Description/Action Possible repair actions