Service Manual

Diagnostic information 2-57
4062
244.33 Tray 4 not ready
Source = Tray 4
Tray was not properly pushed
into the machine.
1. Check the size sensing
fingers on the media tray
for damage
2. Replace the media tray
assembly if problem
remains.
3. Check the switch (media
size) for proper connection.
4. Replace the switch (media
size) if problem remains.
Go to “Switch (media
size) assembly removal
(T650, T652, T654)” on
page 4-74.
244.34 Empty tray pick
attempted
Source = Tray 4
The pick arm attempted to pick
with no media in the tray.
1. Check the media out
actuator for damage.
2. Replace the media out
actuator if problem
remains. Go to “Tray roller
catch assembly removal
(T650, T652, T654)” on
page 4-81.
244.35 Pick page received
while POR not yet
done.
Source = Tray 4
Media remains on the sensor
(input) during the warm up
sequence.
Go to sensor (pass through)
static jam service check.
See “Sensor (pass through)
static jam service check” on
page 2-147.
244.36 Sensor (pass through)
static jam
Source = Tray 4
Media remains on the sensor
(input) during the warm up
sequence.
Go to sensor (pass through)
static jam service check.
See “Sensor (pass through)
static jam service check” on
page 2-147.
244.37 Sensor (pass through)
late jam
Source = Tray 4
The media is late reaching the
sensor (pass through) within
the specified time.
Go to sensor (pass through)
late jam service check.
See “Sensor (pass through)
late jam service check” on
page 2-145.
244.39 Media tray pulled jam
Source = Tray 4
A media tray above the source
tray was pulled during the
printing process.
1. Remove all media present
in media path.
2. Close all media trays.
244.40 Sensor (pass through)
lingering jam
Source = Tray 4
Media reached the sensor
(pass through) within the
specified time but did not clear
it within the specified time.
Go to sensor (pass through)
lingering jam service check.
See “Sensor (pass through)
lingering jam service check.”
on page 2-146.
Error
code or
message
Error contents Description/Action Possible repair actions