Operation Manual

17
2 Volg de aanwijzingen op het scherm om de software van de All-In-One te
verwijderen.
3 Start de computer opnieuw op voordat u de software opnieuw installeert.
4 Plaats de cd in het cd-rom-station en volg de aanwijzingen op het scherm
om de software te installeren. Raadpleeg de installatiehandleiding voor
meer informatie.
Andere ondersteuningsmogelijkheden
U gaat als volgt te werk als de voorgaande oplossingen het probleem met de
All-In-One niet verhelpen:
• Raadpleeg Lexmark Printeroplossingen voor meer informatie over het
oplossen van problemen:
1 Klik op Start Programma's Lexmark 1200 Series
Lexmark 1200 Series Printeroplossingen.
2 Klik op de tab Problemen oplossen aan de linkerkant van het scherm.
• Ga naar onze website op http://lexmark.com/ voor meer informatie.
Kennisgevingen
De volgende informatie is van toepassing op alle kennisgevingen voor dit product:
Kennisgevingen over elektronische emissie
Federal Communications Commission (FCC) compliance information
statement
This product has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult your point of purchase or service representative for additional suggestions.
The manufacturer is not responsible for any radio or television interference caused by using other
than recommended cables or by unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the user's authority to operate this equipment.
Note: To assure compliance with FCC regulations on electromagnetic interference
for a Class B computing device, use a properly shielded and grounded cable
such as Lexmark part number 1021294. Use of a substitute cable not properly
shielded and grounded may result in a violation of FCC regulations.
Note:
Any questions regarding this compliance information statement should be directed to:
Director of Lexmark Technology & Services
Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
[phone]
Industry Canada compliance statement
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Avis de conformité aux normes de l’industrie du Canada
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
Conformiteit met de richtlijnen van de Europese Gemeenschap
Een verklaring van conformiteit met de eisen van de richtlijnen is getekend door de Director of
Manufacturing and Technical Support, Lexmark International, S.A., Boigny, Frankrijk.
Dit product voldoet aan de eisen voor apparaten van Klasse B, zoals omschreven in richtlijn
EN 55022 en in de veiligheidseisen van EN 60950.
Productnaam Lexmark 1200 Series
Type apparaat 4476-005
4476-006
4476-007
4476-008