Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3

EEI –1381/815 CHAIR

Hardware:

Component:

Bolt M8x50mm x 1

Flat Washer M8 x 9

Chair Back x1

Thank you for purchasing the MODWAY CHAIR!

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Seat Frame x1

Front Leg x2

Spring Washer M8 x 9

Allen Wrench x 1

Bolt M8x57mm x 4

C Bolt M8x90mm x 4

PAGE 1
EEI –1381/815 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes. 3.
PAGE 2
EEI –1381/815 CHAIR STEP 1: Please put Chair Back (1) upside down on a carpeted or padded area. Then open the black fabric which is attached by the Velcro from back to front on bottom of the Seat Frame (2). The inside of the Seat Frame(2) will now be visible. Attach Seat Frame (2) to Chair Back(1) by using 1 piece of Bolt (A), 1 piece of Spring Washer (D) and 1 piece of Flat Washer (E) as shown. Do not fully tighten Bolt (A) at this step.
PAGE 3
EEI –1381/815 CHAIR STEP 3: Insert 1 piece of Front Leg (3) into the upper hole on bottom of the Chair Back (1) as shown. Attach by 2 pieces of Bolt (B), 2 pieces of Spring Washer (D) and 2 piece of Flat Washer (E) as shown. Repeat the same steps for the remaining Front Leg (3). Do not fully tighten Bolts (B) for either leg. 2 3 E D B 3 1 Bx4 Dx4 Ex4 Hardware & Tool required STEP 3: Carefully turn over the chair.