Bathtub Installation

FREESTANDING BATHTUB

INSTALLATION AND MAINTENANCE

Note: If you purchased a brushed nickel trim kit, it must be installed before

installing the bathtub (brushed nickel trim not available on all models).

Warning: Due to the rough handling during shipping or on the job

site, do not install this product until a thorough inspection and water test

has been completed.

Check bathtub for correct model and size. Carefully inspect the tub

for any damage (i.e. chips, scratches, cracks). If at any point during the

pre-installation inspection and water test, you discover a problem with the

bathtub or piping system, do not install the unit and contact us

immediately.

All preinstalled parts must be checked and retightened before

installation.

INSTALL BATHTUB

1. Clean, level, and prepare the floor for installation.

2. Determine the location of the drain pipe on the floor by taking

measurements of the drain and waste location beneath the unit.

3. Place the bathtub in the designated space ensuring that the drain

and waste locations match with that of the tub and adjust the

balancing feet as needed, using a level.

PAGE 1
FREESTANDING BATHTUB INSTALLATION AND MAINTENANCE Note: If you purchased a brushed nickel trim kit, it must be installed before installing the bathtub (brushed nickel trim not available on all models). Warning: Due to the rough handling during shipping or on the job site, do not install this product until a thorough inspection and water test has been completed. Check bathtub for correct model and size. Carefully inspect the tub for any damage (i.e. chips, scratches, cracks).
PAGE 2
(figure 1) 4.After adjusting the balance of the bathtub with a level, use white/clear silicone around the tub base to complete installation.
PAGE 3
CLEANING AND MAINTENANCE 1. The bathtub is usually cleaned with general liquid detergent and soft cloth, do not use the detergent that contains acetone or ammonia water element. When you disinfect the bathtub, please use disinfectant without formaldehyde 2. Surface stain can be rubbed with toothpaste on soft cloth. 3. For the mild abrasions or burns on the surface, you can use wet No.2000 waterproof abrasive paper to polish this area, then buffing the ground where it is polished 4.