Installation Instructions

Troubleshooting

When the application that runs the GPS becomes corrupted somehow and won't allow the GPS to start up, Bootloader will

force the GPS into an update mode so that the GPS can be repaired. There might not be anything wrong with the device

except that it won’t connect to a computer. That’s usually when you’ll need to use the bootloader.

*Resetting the device with bootloader could delete settings and files.

1. GPS power off and unplugged from a computer.

2. Open the updater software

http://www.lezyne.com/support-downloads.php

3. Super/Macro GPS – hold down the LAP and ENTER buttons

• Mini/Micro – hold down the MENU and ENTER buttons

4. While holding the buttons down, plug in the USB cable

5. The updater program will immediately start the update

6. Please allow for the updater to run to completion. Once complete, please wait 15 seconds before removing the USB

cable to allow for any background processes to finish.

Resetting with Bootloader

Resetting to Factory Default

Resetting to factory default will erase stored info on the GPS device and restore it to factory start up settings.

1. Open the updater software http://www.lezyne.com/support-downloads.php

2. Plug GPS device into computer

3. In the upper left corner of the updater program – click on the words “Lezyne GPS Firmware Programmer

4. A pull down box will show and option for “Restore device to factory defaults”, click on this to start the process