User's Manual

Part 15.105 statement

This equipment has been tested and found to comply with the limits for a class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. if this equipment does cause harmful

interference or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following

measures:

ţ Reorient or relocate the receiving antenna.

ţ Increase the separation between the equipment and receiver.

ţ Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

ţ Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Information

WARNING! Read this information before operating the phone.

In August 1996, the Federal Communications Commission (FCC) of the United States, with

its action in Report and Order FCC 96-326, adopted an updated safety standard for human

exposure to Radio Frequency (RF) electromagnetic energy emitted by FCC regulated transmitters.

Those guidelines are consistent with the safety standard previously set by both U.S. and

international standards bodies. The design of this phone complies with the FCC guidelines and

these international standards.

Body-worn Operation

This device was tested for typical body-worn operations with the back of the phone kept

0.59 inches (1.5 cm) between the user’s body and the back of the phone. To comply with FCC

RF exposure requirements, a minimum separation distance of 0.59 inches (1.5 cm) must be

maintained between the user’s body and the back of the phone. Third-party belt-clips, holsters,

and similar accessories containing metallic components may not be used. Body-worn accessories

that cannot maintain 0.59 inches (1.5 cm) separation distance between the user’s body and the

back of the phone, and have not been tested for typical body-worn operations may not comply

with FCC RF exposure limits and should be avoided.