User's Manual

59
CAUTION
Use only the supplied and approved antenna. Use of
unauthorized antennas or modifications could impair
call quality, damage the phone, void your warranty and/
or result in violation of FCC regulations. Do not use the
phone with a damaged antenna. If a damaged antenna
comes into contact with skin, a minor burn may result.
Contact your local dealer for a replacement antenna.
Body-worn Operation
This device was tested for typical body-worn operations
with the back of the phone kept 1.5cm (0.59 inches)
between the user’s body and the back of the phone. To
comply with FCC RF exposure requirements, a minimum
separation distance of 1.5cm (0.59 inches) must be
maintained between the user’s body and the back of
the phone. Third-party belt-clips, holsters, and similar
accessories containing metallic components may not
be used. Body-worn accessories that cannot maintain
1.5cm (0.59 inches) separation distance between the
user’s body and the back of the phone, and have not
been tested for typical body-worn operations may not
comply with FCC RF exposure limits and should be
avoided.
Part 15.19 statement
This device complies with part15 of FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Part 15.21 statement
Changes or modifications that are not expressly
approved by the manufacturer could void the user’s
authority to operate the equipment.
Part 15.105 statement
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.