User's Manual

STAREX-IS BSM Manual
Page:734(877)
Issue:1.
0
SMD-011-PMA210
The above is an example when GUI is not operated in spite of the attempt to
operate GUI called “stmGUI”. It means that libXpm.so.x.xx file does not exist as
shown above. In this case, two problems can be taken into consideration.
6.2.1.2.1. LD_LIBRARY_PATH Setup
Setting up GUI Library is to change the system environment variables called
LD_LIBRARY_PATH . The following is an example of how to set up variables.
setenv LD_LIBRARY_PATH “ paths
”
The above path would be composed of the following contents:
/home/informix/lib:/home/informix/lib/esql:/opt/TclPro1.5/solaris-
sparc/lib:/usr/openwin/lib:/usr/lib:/usr/ucblib:/usr/dt/lib:../DATA/LIB
GUI Libraries are generally installed in “/usr/dt/lib” or “/usr/openwin/lib”.
However, add “:
your_lib_path_dir
” upon using them additionally.
6.2.1.2.2. libXpm File Absence
Even though OS is normally installed, XPM Library is not provided as a basic.
Therefore, it is possible to set up by duplicating XPM Library provided by BSM
and by adding Library to variables. Refer to the above item
“LD_LIBRARY_PATH” for setting up.
6.2.2. If Manager in Remote Area is not operated
For safety, BSM does not allow to use two managers in one system remotely.
Therefore, check to see if it corresponds to the following cases:
6.2.2.1. If the same name is already used
Check to see if the system attempting a remote operation uses the name already.
It is possible to check if it is registered by operating controller on Main BSM
Server. In this case, if the current system does not use the name, it means that it
was abnormally terminated during the previous use. Therefore, it will be
possible to reuse it if Main BSM controller deletes the corresponding host name.