User's Manual

STAREX-IS BSM Manual
Page:748(877)
Issue:1.
0
SMD-011-PMA210
(BTS) other board is abnormal while one
side of dual BCRA is normal
LED red or OFF, BCRA non-
operation/ BCRA HW check
A1501
(BTS)
Generated when both sides of dual
BCRA are abnormal.
BCRA HW mounting check or INIT
LED red or OFF, BCRA non-
operation/ BCRA HW check
A1700
(BTS)
Generated when the other side is
abnormal while one side of dual
BSP(UCPA) is normal
Upon board deletion, reinstall that,
or check FAIL LED ON/R.C
execution/R.C result.
A1701
(BTS)
Generated when both sides of dual
BSP(UCPA) are abnormal. ( Board
deletion, CPU or FPGA Fail)
Upon board deletion, reinstall that,
or check FAIL LED ON/R.C
execution/R.C result.
A1750
(BTS)
Generated when the other side is
abnormal while one side of dual
RCP(RCCA) is normal.( Board
deletion, CPU or FPGA Fail)
Upon board deletion, reinstall that,
or check FAIL LED ON/R.C
execution/R.C result.
A1751
(BTS)
Generated when both sides of dual
RCP(RCCA) are abnormal. ( Board
deletion, CPU or FPGA Fail)
Upon board deletion, reinstall that,
or check FAIL LED ON/R.C
execution/R.C result.
A1760
(BTS)
Generated when BPPA is removed
Check the status of BPPA by status
check command. Check BPPA Slot,
and if normal, check BackBoard Pin,
and if abnormal, replace the board.
A1770
(BTS)
Generated when BPPA application
falls into free running loop, thus
generating watchdog, and Fault -
address/bus error- occurs by BPPA
application malfunction, and
hardware is reset by Low Power
warning
Check the status of BPPA by status
check command. Check BPPA Slot,
and if normal, check BackBoard Pin,
and if abnormal, replace the board
A1800
(BTS)
Generated when 1pps clock
reception from GPS-R fails, or
received clock is wrong.
Check power, 1pps cable and UCPA
H/W.
A1810
(BTS)
Generated when 10MHz Clock
reception from GPS-R fails, or
received clock is wrong
Check power, 10MHz cable and
UCPA H/W.
A1850 Generated when BTS RCMD board is Check if RCMD board is removed