User's Manual

STAREX-IS BSM Manual
Page:749(877)
Issue:1.
0
SMD-011-PMA210
(BTS) deleted. and mount that if removed.
A1860
(BTS)
Generated when CPU or FPGA Fail
occurs in RCMD board.
Check the following as to
RCMD.( check FAIL LED ON/R.C
execution/R.C result)
A2000
(BTS)
Generated when one side of dual PRI
boards of BSPB, BANB is abnormal.
Check power and replace that if
abnormal.
A2001
(BTS)
Generated when both sides of dual
PRI boards of BSPB, BANB are
abnormal.
Check power and replace that if
abnormal.
A2010
(BTS)
Generated when one side of dual PRI
boards of RCCB, DBPB is abnormal.
Check power and replace that if
abnormal.
A2011
(BTS)
Generated when both sides of dual
PRI boards of BSPU, BANU are
abnormal.
Check power and replace that if
abnormal.
A2300
(BTS) Generated when DBPA is removed
Check DBPA Slot, and if normal,
check Backboard Pin, and if
abnormal, replace board.
A2310
(BTS)
Generated when DBPA is removed
or abnormal owing to other cause
Check DBPA Slot, and if normal,
check Backboard Pin, and if
abnormal, replace board
A2320
(BTS) Generated when BUDA is removed.
Check BUDA Slot, and if normal, and
if normal, check Backboard Pin, and
if abnormal, replace board.
A2330
(BTS) Generated 10MHz or PLL(IF,RF,
7.2(DCN case)) or DC power (5Vd,
+/-12Va, 5Va) fail, or reset.
- REF(10MHz) : Check 10M Cable,
and if normal, replace BUDA.
- SYNT1(RF PLL) : Replace BUDA.
- SYNT2(IF PLL) : Replace BUDA.
- SYNT3(7.2MHz) : Replace BUDA.
A2340
(BTS) PACA removal (active high).
Check PACA Slot, and if normal,
check Backboard Pin, and if
abnormal, replace board.
A2350
(BTS)
- power fail : TTL
- H/W, S/W Reset
- PLL LOCK Fail (TTL)
- GPS 10MHz Reference Signal
Fail(TTL)
- H/W, S/W Reset : auto recovery
- PLL Lock Fail : Check RCCA
status or replace board.
- GPS Signal Fail : Check PACA GPS
Input Cable.