User's Manual

STAREX-IS BSM Manual
Page:752(877)
Issue:1.
0
SMD-011-PMA210
(BTS) End or detect the status of supplied
voltage and RF device, and
composite them for provision at
TTL Active High upon fail with one
pin.
A2700
(BTS)
Reports the status of HPA
insertion/deletion.
Check if HPA cable is normal.
A2710
(BTS)
HPA DC power off or power failure.
Check if HPA DC power is normally
supplied.
A2720
(BTS)
A2730
(BTS)
A lot of RF power reflected on HPA
output port.
Check if HPA RF output cable
connection is normal / replace RF
output cable.
A2740
(BTS)
HPA disables. Send HPA enable command.
A2750
(BTS)
High HPA temperature
Check if fan that provides ait flow to
HPA is normal.
A2760
(BTS)
High input Power level / disable
alarm along with Over Power
warning alarm is defined as over
power alarm.
Check if RF input power level is
high, which is applied to HPA.
A4600
(BSC)
Generated if alarm cable connected
to CCSB, ASMB, ALSB, SLB, VCB
Shelf is deleted.
Check the status of Alarm Cable, and
replace that if normal.
A4800
(BSC)
Abnormal FAN in BSC.
Check FAN Alarm Cable, and replace
FAN if normal.
A5500
(BSC)
Generated when the other side is
abnormal while one side of dual
NCP(UCPA) is normal.( Board
deletion, CPU or FPGA Fail)
Reinstall board upon deletion, or
check FAIL LED ON/R.C
execution/R.C result.
A5501
(BSC)
Generated when both sides of dual
NCP(UCPA) are abnormal. ( Board
deletion, CPU or FPGA Fail)
Reinstall board upon deletion, or
check FAIL LED ON/R.C
execution/R.C result.
A5510 Generated when the other side is
abnormal while one side of dual
Reinstall board upon deletion, or
check FAIL LED ON/R.C