User's Manual

STAREX-IS BSM Manual
Page:769(877)
Issue:1.
0
SMD-011-PMA210
ABN_F Abnormal Fault
(Test: As a result of DSP Chip Hardware test, NOK)
ABN_M Abnormal MMC Block
INIT Initial
AB_OB Abnormal Online Block
IDLE Idle (CE, VCE)
BUSY Busy (CE, VCE)
N_EQP Not Equipped in PLD
READY Device mounted although not defined in PLD
UNDEF Undefined status
ABN_I H/W Reset isolation
ABN_B On-demand BER Test status
NOR_PB Status until call is disconnected if there is a call when blocking CHC, Chip,
Status until call is terminated for vocoder test
REDNCY Standby side Redundancy (FETA Only)
CB_OPN Faulty Cable Open
CLK_F As a result of Timing-Module test, NOK (Test Only)
TSW_F As a result of TSLU Loopback test, NOK (Test Only)
ABN_AT Auto test of vocoder (Online) (Test Only)
ABN_MT Manual test of vocoder (Ondemand) (Test Only)
QAT0_F As a result of QCELP Algorithm test, NOK in State0 (Test Only)
QAT1_F As a result of QCELP Algorithm test, NOK in State1 (Test Only)
QAT2_F As a result of QCELP Algorithm test, NOK in State2 (Test Only)
QAT3_F As a result of QCELP Algorithm test, NOK in State3 (Test Only)
VPLB_F As a result of VCPA Loopback test result, NOK (Test Only)
VMLB_F As a result of VCMA Loopback test result, NOK (Test Only)
VLLB_F As a result of VLIA Loopback test, NOK (Test Only)
7.3. DCI Debugger Command
7.3.1. Tx/Rx Message Trace Function
This function includes asf, arf command, etc. asf command trances message from BSM
to lower processor, and arf command traces message from lower processor to BSM.
7.3.1.1. asf Command