User's Manual Part 2

STAREX-IS BSM Manual
Page:309(877)
Issue:1.
0
SMD-011-PMA210
4.3.5.18. POWER CONTROL Parameter Information (1) Change
To change POWER CONTROL Parameter information (1), click CDM-
>Change_Parameter_ Information_2-> CHG-PWR1-CTRL on the Command Window in
order. Input the value to be changed in each field as shown below.
• Command CHG-PWR1-CTRL :BSC=a ,BTS=b ,FER=c [,PWR_CNT_STEP=d]
[,FPC_MODE=e] [,FPC_FC_INIT=f] [,FPC_FC_MIN=g]
[,FPC_FCH_MAX=h] [,FPC_DCC_INIT=i] [,FPC_DCC_MIN=j]
[,FPC_DCC_MAX=k] [,FPC_SC_INIT=l] [,FPC_SC_MIN=m]
[,FPC_SC_MAX=n]
[,FPC_THRESH=o] [,FCH_THSH_SC=p] [,FCH_ADJ_GAIN=q]
[,DCC_ADJ_GAIN=r] [,SC0_ADJ_GAIN=s] [,SC1_ADJ_GAIN=t]
[,FPC_SUBCH=u] [,RL_GAIN_ADJ=v] [,RL_TC_PICH=w]
[,RL_SC_PILOT=x];
• Input CHG-PWR1-CTRL :BSC=0 ,BTS=0 ,FER=30,PWR_CNT_STEP=255;
• Output