User's Manual Part 2

STAREX-IS BSM Manual
Page:312(877)
Issue:1.
0
SMD-011-PMA210
4.3.5.20. POWER CONTROL Parameter Information (3) Change
To change POWER CONTROL Parameter information (3), click CDM-
>Change_Parameter_ Information_2-> CHG-PWR3-CTRL on the Command Window in
order. Input the value to be changed in each field as shown below.
• Command CHG-PWR3-
CTRL :BSC=a ,BTS=b ,FER=c ,USE_REV_P=d ,USE_TUB_ENC=e
[,GAIN_19200=f] [,GAIN_38400=g] [,GAIN_76800=h] [,GAIN_153600=i]
[,GAIN_307200=j] [,GAIN_614400=k] [,GAIN_28800=l]
[,GAIN_57600=m] [,GAIN_115200=n] [,GAIN_230400=o]
[,GAIN_460800=p] [,GAIN_1036800=q];
• Input CHG-PWR3-CTRL :BSC=0 ,BTS=0 ,FER=0 ,USE_REV_P=NOUSE_REV_P ,
USE_TUB_ENC=NOUSE_TUB_ENC,GAIN_19200=255;
• Output
Fig. 4.3-120 POWER CONTROL Parameter Information (3) Change