User's Manual Part 2

STAREX-IS BSM Manual
Page:337(877)
Issue:1.
0
SMD-011-PMA210
4.3.8. Configuration Information Change
(Change_Configuration_Data)
This section describes commands that are used to add or delete BTS and BSC
processors and devices. The configuration information that can be added and deleted
are presented below. For the command that has many parameters to input, input image
on the inpout Widow. This section does not cover details of each parameter.
Table 4.3-4 Configuration Information Change
CRN MMC Description
C2312 CHG-BTS-CONF BTS configuration information change
C2315
CHG-CHIP1-CONF
Channel Card Chip configuration
information(1) change
C2317
CHG-CHIP2-CONF
Channel Card Chip configuration
information(2) change
C2333 ADD-PDSN-CONF PDSN CONFIG addition
C2334 RMV-PDSN-CONF PDSN CONFIG deletion
C2335 CHG-PDSN-CONF PDSN CONFIG change
C2337 ADD-PDSN-NODE PDSN NODE addition
C2338 RMV-PDSN-NODE PDSN NODE deletion
C2339 CHG-PDSN-NODE PDSN NODE change
C2601 MOV-BSC-NODE BSC Node movement
C2602 MOV-PCF-NODE PCF Node movement
C2603 MOV-SMP-NODE SMP Node movement
C2604 MOV-VMP-NODE VMP Node movement
C2605 MOV-BTS-ID BTS ID movement
C2606 MOV-BTS-TRNK BTS TRUNK Node movement
C2607 MOV-LICA-LINK LICA LINK movement
C2610
MOV-OVHD-CONF
OVERHEAD CHANNEL configuration
information movement
C2701 ADD-BSC-CONF BSC configuration addition
C2702 RMV-BSC-CONF BSC configuration deletion
C2711 ADD-PCF-CONF PCF configuration addition
C2712 RMV-PCF-CONF PCF configuration deletion